Configuring Windows 95B | Actiontec electronic 56K V.90 specification

Configuring Windows 95B

Step 1 Upon startup, Windows 95 detects the modem and launches the Update Device Driver Wizard dialog box. Insert the modem’s installaiton CD- ROM, wait ten seconds so that the CD can be read, then click Next.

Step 2 After Windows 95 has found the updated drivers for your modem, click Finish.

Step 3 If Windows asks for an installation disk, click OK and type the drive letter of your CD-ROM drive in the dialog box that appears and click OK.

Step 4 After the Wizard has copied the .INF files to the hard disk, it should detect “Wave Device for Voice Modem” and prompt for its driver. Click Next.

11

Image 12

Actiontec electronic 56K V.90 manual Configuring Windows 95B

Contents

56K V.90 PCI Voice/Fax Windows Modem Table of Contents Introduction For Windows 95 and Windows 98 Installations Do This First For Windows NT 4.0 Installation For Windows 2000 Professional Installation Installing The Modem Hardware Installation Installing The Modem Connecting Devices to the Modem Connecting Devices Configuring Windows Page Configuring Windows 95B Page Configuring Windows Page Next Page Page Configuring Windows NT Page Page Page Configuring Windows 2000 Professional Page Page Page Page Confirming the Installation of the Driver in Windows Page Installing Communications Software Modem’s Voice FeaturesPage Troubleshooting Windows 95/95B/98 More Info Panel Does Not Install Windows NT Common Problems No Dialtone Error Can’t Connect at 56K Uninstalling the Modem Uninstalling in Windows 95 Ltcom.vxd ltwave.inf Page AT Commands Repeat Last CommandAnswer Command ATXn Carrier Control Echo Command DnDial Online Data Character Echo Command Hook Control Monitor Speaker Volume Request ID Information This command turns the speaker on or off Modulation Handshake Return On-line to Data Mode Select Pulse DialingResult Code Control DCE Response Format Result Code Option Extended Result Codes Dial Tone Detect Busy Tone Detect Long Space DisconnectRecall Stored Profile Auto Retrain Data Carrier Detect DCD Control Load Factory Settings DTR Control22bis Guard Tone Control Asynchronous Communications Mode Auxiliary Relay optionLocal Flow Control Selection This Command is effective only for use in Japan View Active Configuration and Stored Profile Data Set Ready DSR Option LSD Zn=x Store Telephone Number \An \BnModem Port Flow Control \Kn Same as 4.Default \Nn \Tn Inactivity Timer \Vn Protocol Result Code \Xn XON/XOFF Pass Through Data Calling Tone V90=x Downstream Rate and Control Enable/Disable Data Compression AT Commands for Testing and DebuggingWrite to/Read from DSP Register Line-to-Line Loopback ATI11 XXX Registers Reference Type Ascii Connection Completion Time-Out Comma Dial Modifier TimeS10 S11 Dtmf Dialing Speed S14 General Bit Mapped Options Status S21S22 S24 Timer to Control Sleep Mode S28 Modulation Enable/DisableS30 Inactivity Timer S32 S37 Dial Line Rate default S35 Data Calling ToneS36 S38 56K Dial Line Rate default S42 Auto Rate default 1, rangeS43 Auto Mode default 1, range S89 Timer to Control Sleep Mode S90S91 S92 No Carrier Result Code FCC Regulations FCC Part 68 RequirementsDeclaration of Conformity Canadian Department Of Communications Cdoc