5-15
Installing ATM Version 2.0x Drivers for Windows NT
9
Change any of the editable parameters in the Adaptec ATM Base Driver/CIP Configuration dialog box, and s elect OK, or, to accept the default values, simply select OK. To reset to default parameters, select Defaults.)Null Encapsulation Select the check box to access another
ATM adapter that uses null
encapsulation or VC multiplexing. If
you do not select this check box, the
default transmission method, LL C/
SNAP (RFC 1577), is used.
Remote IP address If you selected the Null Encapsulation
check box, the Remote IP address
parameter appears. Enter the IP
address of the other ATM adapter with
which you want to communicate.
Parameter Setting
Directory This read-only field contains the
directory where the ATM software is
located.
Port Index Leave this parameter at its 0 default
setting; the Port Index parameter is not
implemented at this time.
IBM Concentrator 8282 Select the check box if you have an
ANA-5910 and are connecting to an
IBM Concentrator 8282.
Autostart Base driver Select the check box to automa tically
start the base driver at boot-up.
Autostart CIP Select the check box to automa tically
start the CIP client driver at boot-up.
Back to Back PVC Select the check box to use the CIP
client in back-to-back mode without
involving the switch.
AARP server address Enter the address of th e CIP ARP
server; 20-byte, 40 hex characters. If
the ARP server address has not been
established, use the default setting.
PVCs Use the PVCs list box to add , change
or remove PVCs.
Paramet er Settin g