8-9
Duralink64 Port Aggregation for Windows NT
Note: The group name may be up to 20 character s. If
you skip this step, the system assigns a default group
name (GroupX).
2In the Link Aggregation Type field, click the appropriate link
type. For a description of Adaptec’s Port Aggregation, see
Chapter 2, Introduction to Duralink64 Port Aggregation.
3In the Available Adaptec Ports box, click the available port to
add to the group, and then click Add.
4Repeat step 3 for each additional port.
Note: You must assign the same co nnecti on type to
each port in the same group.
OPTIONAL. To remove a p ort from the group, click the
approp riate port from the Gr oup Ports box, then click Remove.
5When you are finished configuring the group, click Apply.
6To create another group, repeat steps 1 through 5.
7If you want to rename a group:
aSelect the default group name in the Group(s) list box.
bType the new name.
cClick Apply.
8When you are finished configuring all groups, click OK.
9If SNMP is not set up, you will receive the Setup Message
below. Click OK.
Figure 8- 7. Th is mess age may be ignore d during thi s inst allati on