WARNING: TO ENSURE THAT THE DRIVE IS NOT UNEXPECTEDLY STARTED, TURN OFF and LOCK OUT and/or TAG POWER SOURCE BEFORE PROCEEDING.
FAILURE TO OBSERVE THESE PRECAUTIONS COULD RESULT IN PERSONAL INJURY.
WARNING: Drive shaft assembly is heavy. IMPROPER HANDLING CAN CAUSE
PERSONAL INJURY.
2. Drive Motor Components
a) Drive Motor Replacement
1)Discontinue electrical service to the dryer.
2)Mark and identify the wires that will be removed for proper reinstallation.
3)Loosen the turnbuckle and remove
4) Mark the inside of the shaft before removing the taper bushing (for proper reinstallation).
5)Remove the taper bushing and motor pulley.
Refer to Taper Bushing and Motor Pulley Replacement (Step #3 through Step #6) on page 97.
6)Remove the bolts securing the motor to the motor mount.
7)Install new motor and secure to motor mount.
8)Reinstall motor pulley and taper bushing.
Refer to Taper Bushing and Motor Pulley Replacement (Step #7 through Step #12) on page 97.
9)Reinstall
IMPORTANT: DO NOT OVER TIGHTEN TURNBUCKLE.
10)Rewire the new drive motor in the same order as the wiring from the motor that was removed. Diagram is usually affixed to the side of the motor.
11)Reestablish electrical service to the dryer.
b)
1)Discontinue electrical service to the dryer.
2)Loosen turnbuckle and remove
9 6
