f.
1)Discontinue electrical service to the dryer.
2)Disconnect compressed air supply from the dryer.
3) Remove the
4) Remove the two (2)
5) Loosen the cord grip cap that the valve wire go through.
6)Loosen the appropriate wire on the 
terminal strip.
Identify these wires and make note of their placement.
7)Loosen the bolts holding the assembly to the pneumatic panel.
(For
8)Remove the two (2) 1/4" poly compression fittings (door open - door close).
9)Remove the two (2) 1/4" poly x 1/8" M.P.T. connectors from the valve body.
10)Twist/remove the
11)Remove the muffler off of the valve body.
12)To install new
13)Remove the 1/4" poly compression fitting.
14)Remove the
15)Remove the muffler off of the valve body.
16)To install new
7 9
