L.TUMBLER (Basket) SYSTEM
1.Tumbler Drive System
The tumbler (basket) is supported and driven by four (4) 11-inch diameter drive wheel assemblies. Two (2) of these wheels are attached to a 2-inch diameter idler shaft, while the other four (4) are attached to a 2- inch diameter drive shaft. Each of the wheels is fastened to the shafts by a wheel taper lock bushing.
The idler shaft and drive shaft are each supported by two (2) 2-inch diameter pillow block bearings. These bearings sit on slotted support channels and can be moved inward or outward by the adjustment bolts. This results in raising or lowering the tumbler (basket).
The drive system consists of a shaft mounted gear reducer, two (2) V-belts, and a 7-1/2 HP drive motor. Belt tension can be adjusted by tightening or loosening the gear reducer turnbuckle.
To keep the tumbler (basket) in the middle of the dryer a series of retaining wheels are used in the front and rear of the dryer. The retaining wheels run along the vertical edge of the tumbler (basket) rings. These keep the tumbler from rubbing on the front and rear panels of the dryer.
