7
CONTROL POWER (Off)
This "RED LIGHTED OPERATOR," located on the Right Front Control Door, is for disabling the dryer’s
output control voltage. This push-button is mainly for use as a troubleshooting function.
END OF CYCLE / HEATER FAULT INDICATOR / AIR JET
This amber colored indicator located on the front/top of the dryer has two (2) functions:
1. To indicate that a drying cycle has been completed and that the dried material is ready for attention. Once the
dryer is attended (i.e., lint drawer is opened, or the “UNLOAD - DRY- LOAD” selector is turned to either
the “UNLOAD” or “LOAD” position and the vertical doors open) the indicator will go off.
2. To indicate that a “HEATER FAULT” has occurred.
Note that during a “HEATER FAULT” this indicator will flash in conjunction with the “HEATER FAULT"
indicator/reset push-button” located on the Right Front Control Door. Refer to the “HEATER FAULT"
Indicator/Reset Push-Button explanation on the previous page (page 6), for more information concerning
“HEATER FAULTS.”
3. The Air Jet will be activated at the end of the drying cycle when the “END OF CYCLE “light has been
energized. The Air Jet will remain active for approximately thirty (30) seconds to remove lint which may
have accumulated on the Blower Wheel (squirrel cage).