CONFIGURE AND VIEW STATUS

In this chapter, you configure the Megabit Modem CRA-C or view system status using an ASCII terminal connected to the console port. Go to

the following sections:

To complete this task

Go to page

 

 

Connect to an ASCII terminal

17

How to log on and navigate the menus

19

How to configure a remote unit

23

Configure the system settings

24

Configure the ADSL transceiver

26

Configure the Bridge/Router

30

View status

41

Log out

49

Connect to an ASCII Terminal

Connect the Megabit Modem CRA-C to an ASCII terminal:

1Plug the console adapter into the standard 9-pin COM port on the ASCII terminal and tighten the captive screws until they are snug (Figure 7). (Skip this step if the ASCII terminal has an RJ-48 jack.)

2Connect one end of the silver console cable to the console adapter.

3Connect the other end of the silver console cable to the console port on the Megabit Modem CRA-C rear panel.

Megabit Modem CRA-C User Manual

17