Install the Megabit Modem CRA-C

Power Up and Check LEDs

Install the power cable and power up the Megabit Modem CRA-C:

1Plug the mini-DIN connector on the wall-plug supply into the power connector on the rear of the Megabit Modem CRA-C, then plug the wall-plug supply into the facility power.

Do not connect any other wall-plug supply to the Megabit Modem CRA-C. If you use another wall-plug supply, you can permanently damage the unit.

2Turn ON the ON/OFF switch on the rear panel. The unit enters a self-test mode with the following LED indications:

•ADSL STAT LED flashes green

•ADSL SYNC LED flashes green

•Power LED lit solid green

Allow the Megabit Modem CRA-C approximately 30 to 60 seconds to synchronize with the Megabit Modem CRA at the other end of the ADSL line.

3Verify the following LED indications (after the self test is completed):

•10BASE-T LINK LED is solid green (when the Ethernet port is connected)

•ADSL SYNC LED is solid green

•ADSL STAT LED is solid green

•ADSL MAR LED is solid green

If conditions other than those listed above exist, check the installation. See Table 2 for a description of the front panel indications.

16

Megabit Modem CRA-C User Manual