Connecting Power and Turning On
Note
Turning on the host computer first ensures that the SCSI bus terminators stabilize the bus signals before the tape drive is turned on.
Step 1 Plug the power cord into the back of the 4000/ 7000DLT Series.
Step 2 Plug the power cord from the 4000/7000DLT Series into a GROUNDED electrical outlet.
Step 3 Plug the power cord from your host system into the same GROUNDED electrical circuit if possible. Computers and peripherals should always share the same grounds.
Step 4 Turn ON the power to your host system.
Step 5 Turn the 4000/7000DLT Series power ON.
Installing the Backup Software
At this point, please refer to your backup software installation guide and install the backup software.
After you have completed installation of your 4000/7000DLT Series and the backup software, you should run a small backup/restore and compare to confirm that your unit is working correctly. See your software installation guide for additional information.
Connecting Power and Turning On | |
|
|
|
|
