AGFA 300, 600 - page 33

Chapter 3 — Installing the s c anner for the PC 33
5. Snap the diamond shaped wire clips into the clip brackets to secure the
connection.
In case of problems, refer to Appendix C, “Troubleshooting” .
If your Sn apScan will b e connected to your computer together with other SCSI
devices:
■If you install the scanner at the end of your SCSI chain:
1. Remove the terminator from the last device in the SCSI chain.
2. Connect the 50-pin end of the SCSI cable to the connector that has become
available on this device.
3. Put the terminator on the free 50-pin connector of the scanner.
4. Connect the 25-pin end of the SCSI cable to the free connector of the
scanner.
5. Snap the diamond shaped wire clips into the clip brackets to secure the
connection.
In case of problems, refer to Appendix C, “Troubleshooting” .