Agilent Technologies 6038A 6010A Unmask?, Fault?, SRQ OFF SRQ SRQ on SRQ SRQ? CLR ERR?, Srq Off

Command

UNMASK?

Table 3-7 GP-IB Commands (continued)

*Range or **Response		Page
To Query	Description
**UNMASK xxx		62
	Used to read which bits in the status register have
	been enabled to set bits in the fault register
	(i.e.,which power supply conditions are defined as
	faults). xxx is decoded using bit weights in Table
	3-9.

FAULT?

**FAULT xxx

Used to read which bits have been set in the fault register. A bit is set in the fault register when the corresponding bit in the status register changes from inactive to active AND the corresponding bit in the mask register is set. Bits in the fault register are reset only after the fault register is read. xxx is decoded using bit weights in Table 3- 9.

62

SRQ OFF SRQ 0

SRQ ON SRQ 1

SRQ?

CLR

ERR?

	Enable or disable power supply’s ability to request	62
	service from the controller for fault conditions.
	UNMASK command defines which power supply
	conditions are defined as faults. Initial Condition:
	SRQ OFF
**SRQ 0 or	Used to read SRQ setting.	63
**SRQ 1
	Used to initialize power supply to power-on state;	63
	also resets the PON bit in the serial poll register.
	The device clear interface message performs the
	same function.
**ERR xx	Used to determine type of programming error	63
	detected by power supply. A remote programming
	error will set the ERR bit in the status register,
	which can be enabled by UNMASK to request
	service. See Table 3-10 for descriptions of error
	codes.

Operating Instructions 53