Agilent Technologies FS2331 specification

FS2331 100 pin Connector to Pod Diagram

Four 100 pin SAMTEC

connectors on the FS2331

J1

J2

J3

J4

Four - E5385A or E5378A adapter cables

connecting to the logic analyzer

POD 1 (odd)

POD 2

POD 3 (odd)

POD 4

POD 5 (odd)

POD 6

POD 7 (odd)

POD 8

E5385A adapter cables (FS1015) are used to connect to the following logic analyzer cards:

1671X, 16750/1/2/3

E5378A adapter cables (FS1014) are used to connect to the following logic analyzer cards:

1676X, 16754/5/6

7

Image 7

Agilent Technologies user manual FS2331 100 pin Connector to Pod Diagram

Contents

Revision DDR Sdram Analysis Probe FS2331 How to reach us Product Warranty Signal Connections For Sales and Marketing Support For Technical Support Limitation of warranty Product WarrantyExclusive Remedies Logic Analyzer Modules Probe Cable, Connector NumberingIntroduction Definitions FS2331 100 pin Connector to Pod Diagram FS2331 Probe Description Probe Feature SummaryProbe Components DDR Data DDR CommandsProbe Design State Clock GenerationPage Pod Clock Domain Clock Rate Probe Pod Assignment Probe Switch Settings Switch # Default factory Function PositionOn closed Connecting the Probe to the Logic Analyzer Logic Analyzer Signal Threshold Voltage SettingsConnecting Power to the FS2331 Probe Card Requirements for PC2700 Systems 16753/4/5/6 Logic Analyzer Card RequirementsRecommended 169xx Licensing Setting up the 167xx AnalyzerSetting up the 169xx Analyzer Software Requirements System Software Timing Analysis All DDR speeds and supported analyzer cards Card Configurations for State Analysis Probing multiple DDR busses Interleaved memory If User is dedicating a Connecting to your Target System Chip Select § Isolate the Dedicated DIMM’s pin Chip Select Jumper locations § Sleeve the Pin Unused Pods § Wire from the adjacent Dimm slot to the isolated pin Offline Analysis Filtering Taking a Trace, Triggering, and Seeing Measurement Results Loading the Inverse Assembler and Decoding DDR CommandsTiming Analysis Operation State Analysis Operation Inverse Assembler and Decoding DDR Commands Tracing the Serial Presence Detect Signals Using Eye Finder with the FS2331 DDR Probe Using EyeScan with the FS2331 Probe Dimm Signal Loading Option Using the FS2331 DDR Probe with an Interposer FS1024/25 FS2331 Calibration Page Set Command sample position Page Page Write Burst Data Valid Position Page Page Page Read Burst Data Valid Position Page Page Page Set the final analyzer sample position Adjust the delay line value to maximize R/W overlapPage Standards supported General Information Samtec Signal Connections J1 Data SA0 CB4 J2 Data and Command Spare J3 Command and Data Buffcmdclk DM5DQS14 J4 Data DQS7