Agilent Technologies N3280A Scpi Programming Commands At a Glance, Subsystem Commands Syntax

6 – Language Dictionary

SCPI Programming Commands - At a Glance

Table 6-1. Subsystem Commands Syntax
ABORt	Resets the trigger system to the Idle state
CALibrate
:CURRent
[:LEVEL] (@channel)	Calibrate output current and low current measurement range
:LIMit
[:POSitive] (@channel)	Calibrate positive current limit
:NEGative (@channel)	Calibrate negative current limit
:MEASure <max_val>, (@channel)	Calibrate high and medium current measurement range
:DATA <n>	Enters the calibration value
:DATE <date>	Sets the calibration date
:LEVel <level>	Advance to next calibration step (P1 P2)
:PASSword <n>	Set numeric calibration password
:SAVE	Save new cal constants in non-volatile memory
:STATE <bool> [,<n>]	Enable or disable calibration mode
:VOLTage (@channel)	Calibrate output voltage and voltage measurement range
INITiate
[:IMMediate]
:NAME <name>	Enable the named trigger system (TRANsient ACQuire)
FETCh
:ARRay
:CURRent [:DC]? (@list)	Returns the digitized instantaneous current
:VOLTage [:DC]? (@list)	Returns the digitized instantaneous voltage
[:SCALar]
:CURRent [:DC]? (@list)	Returns output current dc measurement
:VOLTage [:DC]? (@list)	Returns output voltage dc measurement
MEASure
:ARRay
:CURRent [:DC]? [max_val,] (@list)	Digitizes and returns the instantaneous output current
:VOLTage [:DC]? (@list)	Digitizes and returns the instantaneous output voltage
[:SCALar]
:CURRent [:DC]? [max_val,] (@list)	Digitizes and returns average (dc) output current
:VOLTage [:DC]? (@list)	Digitizes and returns average (dc) output voltage
OUTPut
[:STATe] <bool>, (@list)	Enables/disables the selected dc source output
:OSCProtect
[:STATe] <bool>, (@list)	Enables/disables oscillation protection on the selected output
:PROTection
:CLEar (@list)	Reset latched protection
SENSe
:CURRent[:DC]
:RANGe [:UPPer] <max_val>, (@list)	Selects the current measurement range
:FUNCtion <function>, (@list)	Configures the measurement sensor ("VOLTage" "CURRent" )
:SWEep
:NPLCycles <n>	Sets the number of ac power line cycles
:OFFSet
:POINts <n>	Defines the trigger offset in the measurement sweep
:POINts <n>	Defines the number of data points in the measurement
:TINTerval <n>	Sets the measurement sample interval
:WINDow [:TYPE] <type>	Sets measurement window function (HANNing RECTangular)

54