Agilent Technologies N9010A specifications

ISDB-T Measurement Application

N6155A, ISDB-T/TSB Measurement Application

c.The sensitivity is specified with 0 dB input attenuation. It represents the noise limitations of the ana- lyzer. It is tested without an input signal. The sensitivity at this offset is specified in the default 10.0 kHz RBW, at a center frequency of 713.142857 MHz.

d.The relative accuracy is a measure of the ratio of the power at the offset to the main channel power. It applies for spectrum emission levels in the offsets that are well above the dynamic range limitation.

Description	Specifications	Supplemental Information
Modulation Analysis Settings
Radio Standard	ISDB-T or ISDB-TSB
Segment Number	13 Segment for ISDB-T
	1 or 3 Segments for ISDB-TSB
FFT Size	2K, 4K, or 8K	Auto-Detection or Manual Input
Guard Interval	1/4, 1/8, 1/16 or 1/32	Auto-Detection or Manual Input
Partial Reception	On or Off	Auto-Detection or Manual Input
Layer A	Segment Count =1 (Partial	Auto-Detection or Manual Input
	Reception=On) or number
	maximum to 13 (ISDB-T)
	Segment Count =1
	(ISDB-TSB)
	Modulation Format:
	QPSK/16QAM/64QAM
Layer B	Segment Count = number	Auto-Detection or Manual Input
	maximum to 13-LayerA Segments
	(ISDB-T)
	Segment Count = 2
	(ISDB-TSB)
	Modulation Format:
	QPSK/16QAM/64QAM
Layer C	Segment Count = number	Auto-Detection or Manual Input
	maximum to 13-LayerA
	Segments-LayerB Segments
	Modulation Format:
	QPSK/16QAM/64QAM
Spectrum	Normal or Invert
Clock Rate	8.126984 MHz	Auto or Manual
Demod Symbols	4 to 50

Chapter 21 227