Configuring your Raven-E for the Host RJ-11 IP Gateway

Installation

If you will be connecting the Host RJ-11 IP Gateway to a Raven-E, you will need a cross-over Ethernet cable to configure your Raven-E unless your computer’s Ethernet port is auto-sensing.

The Host RJ-11 IP Gateway has an auto-sensing Ethernet port, you can use either a cross-over cable or a straight-through Ethernet cable to connect the Host RJ-11 IP Gateway to the Raven-E or your computer.

•Power supplies and a power source - You will need a power supply and power source for both the Host RJ-11 IP Gateway and the Raven-E (as applicable).

•PC or Laptop - To configure both the Host RJ-11 IP Gateway and the modem (as applicable), you will need a computer with Internet Access, other than the cellular account, and an available Ethernet port.

Cellular Account Required

•Cellular Account - If you will be connecting the Host RJ-11 IP Gateway to a Raven-E, you need to already have an active account with a cellular provider and to have activated your modem with that provider. The AirLink Raven-E is certified to work with a variety of cellular providers.

If you need to activate your modem, you can use the Setup Wizard for your cellular provider which you can obtain from the AirLink website: http://www.airlink.com/support/.

Important Information about Ports

•Port Blocking - Many cellular providers and other ISPs block ports below 1024 which are the default ports for many server protocols (such as HTTP, telnet, and SSH). If your provider blocks these ports, you will need to configure a port you can access.