Airlink manual AT Commands, Appendix B, Host RJ-11 IP Gateway User Guide, version

APPENDIX B

AT Commands

In addition to the web-based interface, you can use some typed AT Commands with the Host RJ-11 IP Gateway. To enter AT commands, you need to be connected to the device via telnet or by using the RJ-11 port as you would a standard analog modem.

All AT command strings, with the exception of the break sequence (“+++”) and the repeat com- mand (“A/”), must be terminated with the command line termination character, defined in S3 (default is CR). All characters before 'AT' are ignored. Unsupported commands are ignored and generate an “OK” result code. Multiple commands may be combined on a single line, however the AT command string is currently limited to 40 characters.

Example: AT&FE0V0

Command	Function	Response
/	Repeat last command	Varies
		Note: Command executes upon “/” character,
		CR not needed.
<blank>	Attention	OK(0)
A	Answer	OK(0), NO CARRIER(3)
D	Dial	CONNECT(1), NO CARRIER(3)
		If suffixed with “;” character, will return to com-
		mand mode upon connection.
En	Echo Mode	OK(0)
	0=Turn command echo off
	1=Turn command echo on (default)
Hn	Hang-up or Terminate connection.	OK(0)
	Optional argument has no function
In	Information	Varies
	0=Serial Port Speed	Actual value equals current port speed
	3= Model and Version	NDS/5102 (2 Port, RJ-45) v01A
O	Return to data mode from command
	mode
Qn	Result Codes
	0=Enable result codes (default)	OK(0)
	1=Supress result codes	<blank>

Host RJ-11 IP Gateway User Guide, version 40