Airlink manual Host RJ-11 IP Gateway Serial Settings, Configuration Settings and Commands

Configuration Settings and Commands

•Ethernet Address: MAC Address of the Host RJ-11 IP Gateway.

•IP Address: The current IP Address of the Host RJ-11 IP Gateway and how the IP address was assigned (in the example, a Raven-E in Public Mode used DHCP to give the Host RJ-11 IP Gateway the IP addressed assigned by the cellular network).

•IP Netmask: The current subnetmask of the Host RJ-11 IP Gateway and how the device obtained it.

Serial Settings

The Serial Settings page allows you to specify the baud rate, protocol, character size, parity, stop bits, and flow control behavior for the RJ-11 port (Phone).

Note: For most configurations, the default settings (shown in the screen shots) are best. Change these parameters only if you know the device you will be connecting to the Host RJ-11 IP Gateway requires special settings.

FIGURE 4. Host RJ-11 IP Gateway: Serial Settings

•Enabling flow control enables it on both input and output.

•The inactivity time-out shuts down the service on the port if there is no input or output in the specified time-out period.

Host RJ-11 IP Gateway User Guide, version 21