MAINTENANCE
MAINTENANCE
CUTTERSHAFT BEARING REPLACEMENT (Cont’d)
INBOARD (DRIVE) BEARING. (Mnt-FL-0023 & Mnt-FL-0058)
7.Remove Belt Guard.
8.Remove spring from idler arm.
9.Remove motor mounting bracket fasteners, at the cutterhousing. Pivot
10.Remove fasteners that secure pulley to cuttershaft. Remove pulley and key.
11.Remove fasteners securing inboard bearing and housing assembly to cutterhousing, then remove bearing and housing assembly. Refer to Illustration 11.
NOTE: There are two tapped holes in the housing which can be used to pull bearing and housing assembly pull by using special tool No. 701627.
12.Using a jack to align parts, install inboard bearing and housing assembly to cutter unit. Grease bearing and install cap over fitting.
13.Reinstall key and pulley. Secure with cuttershaft fasteners.
14.Remove jack and check shaft rotation. Reinstall knives which were removed.
15.Reinstall drive belts then secure motor mounting bracket to cutterhousing.
16.Reinstall idler arm spring.
17.Reinstall belt guard.
18.Remove supports, lower unit to ground and test unit. Reinstall outboard fender, if not already installed.
VERSA PRO 03/09 | Maintenance Section |
© 2009 Alamo Group Inc.
