Alamo 803350C manual Operation, Front Mower Specifications

OPERATION

88” Cutting Width

Two 10-Gauge Unitized Cutter Housings

1/2” Inboard and 5/16” Wall Cuttershaft Replaceable Skid Shoes

4-1/2” x 5/16” Wall Cuttershaft

1-5/16” Bore Greasable, Self-aligning Cuttershaft Bearings 53 HP Motor

Belt Drive From Motor to Cuttershaft with Automatic Spring Tension 6” Adjustable Rear Roller

1/2” to 6” Cutting Height Available in Fine or Coarse-Cut Front and Rear Safety Deflectors Automatic Cut-Off Switches

Wing Cylinder Capable of 145 degrees Down & 90 degrees Up

FRONT MOWER SPECIFICATIONS

96” Cutting Width

10-Gauge Unitized Cutter Housing 5/16” Side Plates

4-1/2” x 5/16” Wall Cuttershaft

1-5/16” Bore Greasable, Self-aligning Cuttershaft Bearings 60 HP Gearbox

6” Adjustable Rear Roller 1/2” to 6” Cutting Height Available in Fine or Coarse Cut Front and Rear Safety Deflectors

Belt Drive from Gearbox to Cuttershaft with Automatic Spring Tension

The Mower is designed for certain mowing applications and is rated to cut up to a specific size vegetation (see Mower Standard Equipment and Specifications). DO NOT use this mower to cut vegetation above the Mower’s rated capacity or to cut any type of non- vegetative material. Only operate this Mower on a properly sized and equipped Tractor. Operating this Mower in an application for which it is not designed and/or operating the Mower with the wrong size Tractor can cause Mower component damage and equipment failure resulting in possible serious injury or death. (SGM-14)

VERSA PRO 03/09 Operation Section 4-3

© 2009 Alamo Group Inc.

OPERATION