ASSEMBLY
DRIVELINE ATTACHMENT
Pull slide collar back and attach one end to the Tractor PTO. Move yoke back and forth until locking collar "clicks" forward and locks the yoke in place. Do the same to the other end of the Driveline on the Speed Increaser shaft.
CENTER & WING MOWER ASSEMBLY
Tip cutterhousing back and place a block under roller to safely support unit. Remove shipping skids and drive pulley side belt guard fender. If necessary, install knives, as shown, one row at a time. See rotation below. FOR FORWARD ROTATION: On the right wing and center unit, all knife pins must be installed with their heads facing away from the cuttershaft pulley. On the left wing, the heads of the knife pins must face the cut- tershaft pulley.
FOR REVERSE ROTATION: On the right wing and center unit, all knife pins must be installed with their heads facing toward the cuttershaft pulley. On the left wing, the heads of the knife pins must face away from the cut- tershaft pulley.
This will locate cotter pins where knives cannot reach them when flexing backward. The housing side sheet has a hole in it which allows knife pins to be inserted into end lugs from outside the cutterhousing. After the
cotter pin is installed, bend extended prong at a 45 Degree angle with prong parallel to lug.
With the cutterhousing tipped up, attach housing shoes/wear plate. Carriage bolt attaches to front mounting hole; plow bolts attach to middle and rear holes.
VERSA PRO 03/09 | Assembly Section |
© 2009 Alamo Group Inc.
ASSEMBLY
