OPERATION
OPERATION
Roller Height Adjustment
The mower’s cutting height is set by positioning the roller assembly for each mower section. Each section must be set at the same height to ensure an even cut across the entire width of the mower.
1.Place the tractor and mower on a level surface and completely lower the mower to the ground.
2.Shut down the tractor, place the transmission in park, and set the parking brake before dismounting.
3.One section at a time, place lifting device (scissors jack or hydraulic jack) under center of cutter housing.
4.Remove hex nuts, washers and carriage bolts from bracket at each end of roller. Make certain that roller bracket is free to move once the fasteners are removed. A stuck roller could drop unexpectedly and cause injury.
5.Use lifting device to reposition cutter housing to desired cutting height. Align bracket holes with cutter housing, then reinstall hardware.
6.Lower cutter housing to the ground and remove lifting device.
7.Set cutting height according to procedures above for remaining two cutter sections. Make sure that all three rollers are set at the same height to ensure an even cut across the entire width of the mower.
Leveling Deck
To Facilitate a safe and efficient mowing operation, the mower should be operated parallel to the ground at all times. Never operate if front or rear of mower is tilted upward. Objects may be discharged at high speeds causing possible injury or even death.
Adjust Top Link to level mower roller adjustment. Side Skid Shoes should always be parallel to ground throughout the full adjustment range. Adjust cutting height of machine by raising or lowering rear roller as specified in Operation Section.
VERSA PRO 03/09 | Operation Section |
© 2009 Alamo Group Inc.
