Digital Connections - Chapter 7
Routings
To specific ADAT tracks
To route the Q20Õs digital outputs to specific ADAT tracks depends on which of the 8 channels of the buss you use. If you want to record in stereo onto tracks 1 and 2 of ADAT (or 9 and 10 on ADAT #2 in a chain), route the Q20Õs Left output to channel 1 and its Right output to channel 2. Likewise, if you were recording onto tracks 5 and 6, then it would be channels 5 and 6 that you would use.
To route the Q20Õs Left and Right outputs to the digital buss:
➀Press [GLOBAL].
The [GLOBAL] LED will light.
➁Press [PAGE >] six times to advance to Global Page 6. The display will read:
DIG CH IN: L=1,R=2 OUT: L=1,R=2
➂Press the [PAGE >] button two more times to advance the cursor to the third field in the display.
DIG CH IN: L=1,R=2 OUT: L=1,R=2
➃Use the [VALUE/ENTER] knob to select an output on the digital buss for the Left channel to be routed to.
You can select any of the 8 channels, except for the channel the Right output is assigned to (you cannot route both the Left and Right outputs to the same channel of the digital buss).
➄Press the [PAGE >] button to advance the cursor to the next field.
DIG CH IN: L=1,R=2 OUT: L=1,R=2
➅Use the [VALUE/ENTER] knob to select an output on the digital buss for the Right channel to be routed to.
You can select any of the 8 channels, except for the channel the Left output is assigned to.
➆
You will be able to monitor the Q20Õs output on those tracks of the connected ADAT.
Q20 Reference Manual | 111 |