Chapter 6 - Advanced Applications
Choosing a Target
Once you have selected a Modulator, you must then select the Target to be modulated. The Target is broken down into two parts: first, you choose one of the active Blocks in the current Program, then you choose a parameter within the Block.
➀With [MODULATION] selected (its LED should be lit), press [PAGE >]. The cursor will advance to the second field in the display:
MOD 1 TO:DLY
The cursor appears beneath the Modulator Target Block.
➁Turn the [VALUE/ENTER] knob to select a Block.
The display will look different depending on each BlockÕs defined type. In the display example above, the first Block is a Delay (DLY). The number (1) tells us this is Block #1. If you turn the [VALUE/ENTER] knob, you will see other options defining the BlockÕs type and number (example: PCH 2, EQ 3, OUT L, MIX, etc.).
➂Press [PAGE >] to advance the cursor to the next field in the display.
MOD 1 TO:DLY
The cursor appears beneath the Modulator Target Parameter.
➃Turn the [VALUE/ENTER] knob to select a Parameter to be modulated in the selected Block.
The parameters available will of course depend on the selected BlockÕs type.
Here is a list of possible Target Parameters, listed with each effect type:
Type | Effect | Target |
EQ | Lowpass Filter | Frequency |
| Bandpass Filter | Bandpass Frequency, Bandpass Width |
| Highpass Filter | Frequency |
| Lowpass Shelf | Frequency, Gain |
| Highpass Shelf | Frequency, Gain |
| 1 Band Low/High | Bandpass Gain |
| Parametric | Bandpass Width |
| 2 Band Sweep Shelf | Lowpass Frequency, Lowpass Gain |
|
| Highpass Frequency, Highpass Gain |
| 3 Band Parametric EQ | Lowpass Frequency, Low pass Gain |
|
| Bandpass Frequency, Bandpass Gain |
|
| Bandpass Width |
|
| Highpass Frequency, Highpass Gain |
92 | Q20 Reference Manual |