Description of Controls - Chapter 5
Deferred. The desired value is selected by turning the [VALUE/ENTER] knob, but the new value will only take effect after the [VALUE/ENTER] button has been pressed. The newly selected value will flash in the display until it is selected in this manner. If you change the parameter back to its original setting, the value in the display will not flash. Also, if you go to another Page, or select another Function (by pressing any button), the parameter will be left unchanged. If you went back to look at the previous parameter, it will be set back to its original setting. This mode is used for parameters that cause architectural changes such as changing a BlockÕs function, effect type, and routing signals.
For Power Users. The [VALUE/ENTER] button can also be used to step through Pages in the currently selected mode. Except when a value is flashing on and off in the display, the [VALUE/ENTER] button ordinarily doubles for the [PAGE >] button. If you change the value of a parameter that uses Òdeferred mode,Ó, you must press the [VALUE/ENTER] button to enter the new value (the display will stop flashing), and then you can press it again to move to the next Page (or to the next parameter, if more than one parameter appears in the display). This is a feature for power users who want to be able to move around the various pages quickly and make changes as fast as possible.
✪Unique Exception: When editing the Delay Time parameter of a Delay Block set to either Tap Tempo Mono Delay or Tap Tempo Ping Pong, the [VALUE/ENTER] button is used to ÒtapÓ in a tempo . See Chapter 6 for more information.
Program
This button is used, in conjunction with the [VALUE/ENTER] knob, to select the Program number in the display. When its LED is lit, turning the [VALUE/ENTER] knob selects a different Program, using one of two modes: Direct or Deferred. Direct mode immediately recalls the displayed Program as you turn the [VALUE/ENTER] knob. Deferred mode lets you scroll through the Programs in the display by turning the [VALUE/ENTER] knob, but you must press the [VALUE/ENTER] button to actually recall a Program. You can choose between either Direct or Deferred mode by going to Program Page 2, using the following steps:
To select either Direct or Deferred Program Selection Mode:
➀Press the [PROGRAM] button.
The [PROGRAM] buttonÕs LED will light.
➁Press [PAGE >] to advance to Program Page 2. The display will look like this:
PROGRAM SELECTION MODE: DIRECT
➂Turn the [VALUE/ENTER] knob to select either Direct or Deferred mode.
You can also directly select Programs using the front panel buttons. By holding the [PROGRAM] button, you can press [PRESET] or [USER] (stenciled in gray) to select either the Preset, User 0 or User 1 bank (100 Programs in each). Also while holding the [PROGRAM] button and using the [1] though [0] buttons (stenciled in gray), you can directly recall any Program (from 00Ð99) in the current bank (Preset or User) you happen to be in.
Q20 Reference Manual | 69 |