Your First Session with the Q20 - Chapter 2
Auditioning Internal Programs
You can audition the Programs in the Q20 by using the [VALUE/ENTER] knob or the front panel buttons, whenever the Q20 is in Program mode (the [PROGRAM] buttonÕs LED will be lit).
To select a Program using the [VALUE/ENTER] knob:
➀Press [PROGRAM].
The [PROGRAM] buttonÕs LED will light.
➁Turn the [VALUE/ENTER] knob.
Note: The [VALUE/ENTER] knob has two modes when used for selecting Programs: Direct and Deferred. Direct mode immediately recalls the displayed Program as you turn the [VALUE/ENTER] knob. Deferred mode lets you scroll through the Programs in the display by turning the [VALUE/ENTER] knob, but you must press the [VALUE/ENTER] button to actually recall a Program. For more information on choosing between Direct and Deferred mode, see Chapter 5.
To select a Program using the front panel buttons:
➀Hold the [PROGRAM] button.
➁Use the [1] through [0] buttons to directly select Programs 00 through 99. These are the
The top line of the display will change to indicate the currently selected Program number (from
PROG: Preset 00 "Concert Hall "
PROGRAM
The left side of the display always indicates the currently selected Program number (00 Ð 99). Directly beneath the
PRESET
Switching Between Preset and User Banks
There are three banks in the Q20: Preset, User 0 and User 1. They each contain 100 Programs. However, the Preset bank cannot be permanently changed. You can edit the Preset Programs, but you can store them only in the User banks. To switch between the Preset and User banks, follow these steps:
➀Press and hold the [PROGRAM] button.
➁Use the [< BLOCK] and [< PAGE] buttons to select either PRESET or USER. Press the [< PAGE] again to toggle between the two User banks.
The currently selected Bank will be displayed in the top row of the LCD display. Also, when the Preset Bank is selected, the display will show the word ÒPRESETÓ beneath the PROGRAM number in the lower left corner.
Q20 Reference Manual | 21 |