Section 4 Service Procedures

WARNING

To reduce the risk of electrical shock, fire, explosion, serious injury or death:

•Disconnect electrical power to the washer-extractor before servicing it.

•Close the gas shut-off valve to the washer-extractor (when applicable) before servicing it.

•Never start the washer-extractor with any guards/panels removed.

•Whenever ground wires are removed during servicing, these ground wires must be reconnected to ensure that the washer-extractor is properly grounded.

W461R1

22.KEYMODE SWITCH REMOVAL AND INSTALLATION

Refer to Figure 6.

REMOVAL

a.Turn off power to the machine.

b.Remove the top cover. Refer to Paragraph 19.

c.Disconnect the wires from the keymode switch.

d.Using a 5 mm nut driver, remove the nuts that attach the keymode switch to the control panel.

e.Separate the keymode switch from the keymode base and remove them.

INSTALLATION

a.Position the keymode base and keymode switch and connect them.

b.Using a 5 mm nut driver, replace the nuts that attach the keymode switch to the control panel.

c.Reconnect the wires to the keymode switch.

d.Replace the top cover. Refer to Paragraph 19.

e.Turn on power to the machine.

Keymode Control

Base Panel

CFD11S

Keymode

Switch

Figure 6

9001900

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

69