Section 4 Service Procedures

WARNING

To reduce the risk of electrical shock, fire, explosion, serious injury or death:

•Disconnect electrical power to the washer-extractor before servicing it.

•Close the gas shut-off valve to the washer-extractor (when applicable) before servicing it.

•Never start the washer-extractor with any guards/panels removed.

•Whenever ground wires are removed during servicing, these ground wires must be reconnected to ensure that the washer-extractor is properly grounded.

W461R1

30.MOTOR REMOVAL AND REPLACEMENT (18, 25, 35, 55 and 75-Pound Capacity Models)

REMOVAL Refer to Figure 15.

a.Turn power off to the machine.

b.Remove the rear panel. Refer to Paragraph 24.

c.Remove the drive belt. Refer to Paragraph 26.

d.Loosen the motor pulley’s setscrew and remove the motor pulley from the motor.

e.Remove the motor belt tensioner bolts from the motor plate.

f.Remove the motor mounting bolts from the motor plate.

g.Disconnect the motor wiring.

h.Remove the motor from the machine.

REPLACEMENT

a.Connect the motor wiring.

b.Reinstall the motor onto the motor plate.

c.Reinstall the motor pulley to the motor and check the pulley’s alignment.

d.Reinstall the motor belt tensioner bolts.

e.Reinstall the belt.

f.Re-tension the belt. Refer to Paragraph 26.

g.Replace the rear panel. Refer to Paragraph 24.

Motor

Pulley

Motor

Plate

Motor

CFD13S

Figure 15

9001900

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

75