CDHF-SVU01C-EN
46
Operator
Interface
Each Settings Sub screen consists of a setpoints list and the current value.
The operator selects a setpoint to change by touching either the description or
setpoint value. Doing this causes the screen to switch to the Analog Settings
Subscreen shown below.
Analog Settings Subscreen displays the current value of the chosen setpoint
in the upper ½ of the display. It is displayed in a changeable format consistent
with its type. Binary setpoints are considered to be simple two state
enumeration and will use buttons. Analog setpoints are displayed as spin
buttons. The lower half of the screen is reserved for help screens. To change
the setpoint the ENTER key must be touched, otherwise the new setting is
cancelled.
{Note: Spin buttons used to change
setpoint value.