APC AP9254, AP9258 manual Keyboard Control, Esc

3.2 Keyboard Control

The following notational conventions appear throughout this chapter to illustrate commands for operating the APC KVM Switch. Whenever you see one of the symbols listed on the left side of the table, substitute the corresponding steps or values listed on the right side of the table.

Convention	Key Sequence or Value
	Enter Command Mode:
<CM>	1. Press and hold down the ‘Num Lock’ key.
	2. Press and release the minus (-) key on the numeric keypad.
	3. Release the ‘Num Lock’ key.
	Note: For alternate hot-key sequences, see ‘System Control &
	Maintenance’ later in this chapter.
<Enter>	Press the ‘Enter’ or ‘Return’ key. The <Enter> command is used
	to execute an instruction and exit from Command Mode.
Addr	The numbers over the push-buttons on your APC KVM Switch
	are your servers' addresses. Enter the number, 1-8, for the
	computer you're selecting. For cascaded systems, enter the
	address of the base unit first.
	Example: You have an APC KVM Switch unit cascaded from
	channel 2 of your base unit. To access the computer at
	channel 3 of this second (cascaded) unit, enter 23.
<ESC>	Press the ‘Escape’ key. The <ESC> command is used to exit
	Command Mode without executing an instruction.

9