Replacement Parts

WARNING: All safety instructions in the Safety sheet (990-2984) should be read, understood, and followed prior to handling the system. Failure to do so could result in equipment damage, serious injury, or death.

WARNING: Only trained persons familiar with the construction and operation of the equipment, as well as the electrical and mechanical hazards involved, may install and remove system components.

Note: A maximum of two SmartSlots can be used.

Part

Part number

 

 

16 kW power module for 48, 96 and 160 kW 400 V

SYPM10K16H

 

 

10 kW power module for 100 kW 208V, High Efficiency

SYPM10KF2

 

 

Battery module (four battery units)

SYBT9-B4

 

 

Battery unit

SYBTU2-PLP

 

 

SmartSlot relay I/O module (option)

AP9610

 

 

Modbus/Jbus interface Card (option)

AP9622

 

 

Network Management Card (option)

Go to www.apc.com for a list of Network Management

 

Cards

Power distribution module

Go to www.apc.com for a complete list of breaker

 

 

Replace a Power Management Card

A:Only the cards in these two locations can be replaced.

1.Loosen the two Phillips screws on the sides of the card and carefully pull it out of the enclosure.

2.Install the new card and secure it with the two screws.

Note: The Symmetra PX 100 kW has an embedded NMC. The SmartSlots do not support an additional NMC.

26

Symmetra™ PX48, 96, and 160 kW 400 V 100 kW 208 V Operation

990–3015E-001