Setup

protecting cap

4.2.2 Mounting the CCD Optic Module

protecting capand the Inserter/Antiflicker

Module

•Remove protecting cap of the video tap § by turning it counter-clockwise,

and store it in case the camera is used without the IVS.

•Remove the protecting cap of the CCD optic module § by turning it counter-clockwise.

The video lens must be properly inserted into the lens mount until the end of the thread. Uncomplete insertion might result in damage to the beam splitter when attaching the unit to the camera body.

•Insert the CCD optic module into the video tap of the film camera with the lens first. Make sure the connector is pointing to the left side. Push the CCD optic module into the camera as far as it will go. Twist the module left or right until the key of the lens gear finds its path and insert the module further into the camera. Tighten the screw ring a little but do not close it entirely.

•Place the inserter/antiflicker module on the film camera and connect it to the CCD optic module. Insert the

18