•Lift the top side of the viewfinder carefully off to get access to the beam splitter and mounting ring assembly.
•Open the connector locks with a pair of tweezers and disconnect the cables §.
•Take the viewfinder top off.
•Place the viewfinder unit back to the camera.
•Open the 5 screws of the CCD optic module mount §, but do not take them out.
•Install the CCD optic module and the inserter/antiflicker module according to chapter 4.2.2.
•Remove the cover on the front side of the CCD optic module and make sure that the alginment screws (S1, S2, S3, S4) are in the middle of their range, as described in chapter 4.1.
•Swing the optic unit arround screw 4 and 5 § so that the height of the video image is centered on the video screen.
•Close the screw 3 on the CCD optic module mount
§.
connectors
screw 5 of the optic module mount 
screw 4 of the optic module mount
screw 1 of the optic module mount
screw 2 of the optic module mount
screw 3 of the optic module mount
Setup
21