Functions

24

Note: The reduced running speeds (1 per thousand with switched on NTSC video operation) are displayed as the non-reduced speeds, e.g. 59.94 fps is displayed as 60 fps.

2)In ”0” position (center position) the film transport is stopped.

3)The ”autostop” stops the film run approx. 2 m (6 ft) before the film end.

Attention: Film channel cannot be opened during film run.

6.1.4 Single Frame Operation

If, during still projection, the Master Control Knob is turned only slightly to the right or left of the ”0” position so that film transport has not yet started, single frame release is possible. In this case, a dot appears in the center of the display ➪ photo.

1)By briefly depressing the ”Film” Key, the film is advanced by 1 frame.

2)If the Master Control Knob is turned to the left of the ”0” position, then single frame release to the left becomes active. When turning to the Knob to the right, single frame to the right is activated.

Note:

Single frame operation is also possible via IR

 

remote control.