Frequency/Voltage Control
The following screen shows the Frequency and Voltage Control parameters and their default settings:
Phoenix - AwardBIOS CMOS Setup Utility
Frequency/Voltage Control
Auto Detect DIMM/PCI Clk | [Enabled] | Item Help | |
Spread Spectrum | [Disabled] | ||
| |||
|
| Menu Level X |
KLIJ :Move Enter: Select | F10: Save and Exit ESC:Exit |
F1: General Help F5: Previous Values | F7: Optimized Defaults |
The following table describes the parameters found in this menu. Settings in boldface are the default and suggested settings.
Parameter | Description | Options |
|
|
|
Auto Detect DIMM/PCI Clk | This option allows you to enable/disable the | Enabled |
| feature of auto detecting the clock frequency of | Disabled |
| the installed PCI bus. |
|
Spread Spectrum | When the motherboard’s clock generator pulses, | Enabled |
| the extreme values (spikes) of the pulses creates |
|
| EMI (Electromagnetic Interference). The spread |
|
| Spectrum function reduces the EMI generated by |
|
| modulating the pulses so that the spikes of the |
|
| pulses are reduced to flatter curves. If you do not |
|
| have any EMI problem, leave the setting at |
|
| Disabled for optimal system stability and |
|
| performance. But if you are plagued by EMI, |
|
| setting to Enabled for EMI reduction. Remember |
|
| to disable Spread Spectrum if you are |
|
| overlocking because even a slight jitter can |
|
| introduce a temporary boost in clockspeed which |
|
| may just cause your overlock ed processor to |
|
| lock up. |
|
|
|
|
38 | Chapter 2 |
