
4.JMicron JMB363® Serial ATA RAID connector (7-pin SATA_RAID)
This connector is for a Serial ATA signal cable. This connector supports a Serial ATA hard disk drive that you can configure for RAID through the onboard Serial ATA RAID controller.
The JMicron JMB363 controller item in the BIOS is set to [AHCI] by default, allowing you to use the connectors to build a RAID set. See section “4.4.6 Onboard Device Configuration” for details.
P5B Deluxe |
SATA�RAID
GND
RSATA�RXN1
RSATA�RXP1
GND
RSATA�TXN1
RSATA�TXP1
GND
P5B Deluxe SATA_RAID connector
Before creating a RAID set using Serial ATA hard disks, make sure that you have connected the Serial ATA signal cables and installed Serial ATA hard disk drives; otherwise, you cannot enter the JMicron® JMB363 RAID utility and SATA BIOS setup during POST.
ASUS P5B Deluxe |