Asus P5B manual Front panel audio connector 10-1 pin Aafp

• For a fully configured system, we recommend that you use a power supply unit (PSU) that complies with ATX 12 V Specification 2.0 (or later version) and provides a minimum power of 400 W.

•Do not forget to connect the 4-pin/8pin EATX12V power plug; otherwise, the system will not boot.

•Use of a PSU with a higher power output is recommended when configuring a system with more power-consuming devices. The system may become unstable or may not boot up if the power is inadequate.

•The ATX 12 V Specification 2.0-compliant (400W) PSU has been tested to support the motherboard power requirements with the following configuration:

CPU: Intel® Pentium® Extreme 3.73GHz

Memory: 512 MB DDR2 (x4)

Graphics card: ASUS EAX1900XT

Parallel ATA device: IDE hard disk drive

Serial ATA device: SATA hard disk drive (x2)

Optical drive: DVD-RW

•If you want to use two high-end PCI Express x16 cards, use a PSU with 500W to 600W power or above to ensure the system stability.

10.Front panel audio connector (10-1 pin AAFP)

This connector is for a chassis-mounted front panel audio I/O module that supports either HD Audio or legacy AC`97 audio standard. Connect one end of the front panel audio I/O module cable to this connector.

			AAFP
P5B Deluxe	HD Audio-compliant			Legacy AC 97 audio
	pin definition			pin definition
	GND	SENSE1�RETUR PRESENCE#	SENSE2�RETUR	AGND	NC NC	NC
	PORT1 L	PORT2 R PORT1 R	PORT2 L SENSE�SEND	MIC2	Line out�R MICPWR	Line out�L NC
P5B Deluxe Analog front panel connector

• We recommend that you connect a high-definition front panel audio module to this connector to avail of the motherboard’s high-definition audio capability.

•By default, this connector is set to HD Audio. If you want to connect a AC'97 front panel audio module to this connector, set the Front Panel Support Type item in the BIOS setup to [AC97]. See section 4.4.6

Onboard Device Configuration for details.

ASUS P5B Deluxe 2-33