Avaya 3.7 To add an IP device to the security gateway:

Setting up the network
74 Avaya VPNmanager Configuration Guide Release 3.7
Figure 21: Media interface configuration dialog
Note:
Note: The fields displayed in the screen are based on the type of zone selected.
3. The media option choices depend on the media type selected and the capabilities of the
underlying device hardware and driver. QoS is used by the QoS module to restrict the
bandwidth of the interface to the upstream limit of the network. For exampl e, to allow QoS t o
regulate maximum bandwidth of a 100 mbps to 25 mbps, enter 25 mbps.
4. In the IP Configuration area, make the required changes.
●From the Zone list, select the zone. Only the zones that apply to that media interface are
displayed.
●From the IP Config Mode list, select the IP addressing mode. Depending on your
selection, complete the required information.
●If public-backup is selected, complete the Idle Timer Settings configuration if failover is
enabled.
5. Click Save when you finish.
To add an IP device to the security gateway:
1. From the Configuration Console Contents column, select the security gateway to be
configured. Click the Interface tab to bring it to the front proper ty, select the media interface
that is configured with private, DHCP Server. Click Edit. The Media Interface Configur ation
dialog is displayed.
2. Click IP Devices. The IP Device Configuration dialog is displayed.
3. Enter the following information
●The MAC address of the IP device. If the device is an Avaya IP telephone, the MAC
address is on the back of the telephone.