Setting up the network
58 Avaya VPNmanager Configuration Guide Release 3.7
●DNS Name, to enter the name of the Domain Name Service of the new security
gateway. See DNS tabon page 63.
If the device is already in the network, select the Detect Device checkbox. The default
is selected.
3. In the Private IP Configuration section, enter the following information:
●The private IP address and private mask of the private ethernet port
●Select Use this address when directly communicating with this device, if the
VPNmanager is on the private side of the security gateway and needs to communicate
using the security gateway’s private IP address. Click Next.
Note:
Note: Entering a security gateway IP address from the VPNmanager Console does not
change the security gateway’s address. The address and subnet mask of a
security gateway can only be changed with a computer connected directly to the
security gateway’s console interface. The address entered here is used to
identify the security gateway so VPNmanager Console can communicate with it.
4. In the Authentication section, enter the superuser name and password.
5. If the Detect Device checkbox is selected (default), VPNmanager will attempt to contact the
device and retrieve the device details. Select the device from the drop down menu in the
Network Configuration screen.
6. If the Public Interface Uses a Dynamic (User VPN) IP Address checkbox is selected, enter
the device serial number. Enter the Policy Server IP/DNS name and port where the Policy
Server is running.
7. In the Device Details section, when the Detect Device checkbox selected, VPNmanager
automatically detects the device and updates the device details.
8. If the Detect Device checkbox is not selected, select the device type from the drop-down
menu.
9. In the SNMP Configuration section, enter the following information:
●Select the SNMP version
●Enter the SNMP community string name to which the new security gateway reports
SNMP information. The default is the public community string.
10. If an existing security gateway is being added to the VPN, enter the new community string
name to which the security gateway is to send its SNMP information.
11. In the Static Route area, click Configure Static Route to configure the static route
destination address. Select Add to enter the IP address of the Next Hop for the static rout e.
Up to 32 network address/mask pairs can be configured for the destination network. Click
Ok.
12. Click Next. Select either to Setup Now or to Setup Later. Set up later sends the
configuration information to the directory server, but not to the security gateway.