Examples

To display the settings of all of the ports on the module in slot 3, enter:

show port 3

To display the settings of ports 1 through 5 on the module in slot 3, enter:

show port 3/1-5

To display the settings of ports 1 through 5 on the module in slot 3 and of port 1 on the module in slot 6, enter:

show port 3/1-5,6/1

Setting a Rule in an Access Control List

Command

Use the access list command to set a rule on an access control list. The rule that you set will be applied on all of the ports on the switch. The command syntax is:

*Note: You must enable the access control list on which you want to set a rule. Only one access control list can be enabled at a time.

>configure)# access-list <access-list-name> <access-list-index> {permitdenyfwd1fwd2fwd3fwd4fwd5fwd6fwd7 fwd8} <protocol-id> {<source-ip-addr> <source- wildcard>anyhost <source-ip-addr>} [{lteqgtrange} <port> [<port>]] {<dest-ip-addr> <dest-wildcard>anyhost <dest-ip-addr>} [{lteqgtrange} <port> [<port>]] [established]

A-4

June 14, 2001

610-0184-095

Page 38
Image 38
Avaya P880, P580, P550R manual Setting a Rule in an Access Control List