Avaya P580, P550R Known Problems and Workarounds, ATM Uplink Modules, Command Line Interface CLI

Known Problems and Workarounds

The following known problems and workarounds apply to Cajun P550R, P580, P880, and P882 switches that are running switch software, v5.2.2. If a known problem has a viable workaround, it immediately follows the Problem statement. If the known problem has no viable workaround, it is listed as a bulleted statement.

ARP

Problem:50-Series and 80-Series modules lose ARPs after you perform an initialization of NVRAM (NVRAM init).

Workaround: Reboot the switch twice after performing an NVRAM init.

ATM Uplink Modules

The following problem has no workaround:

■The 50-series ATM Uplink modules do not work in slot 16 or slot 17 if you are using an 80-Series Supervisor module in a Cajun P882 switch.

Command Line Interface (CLI)

The following problem has no workaround

■The “!” character, when used as part of a CLI command, is considered a comment by the Cajun switch software:

—If you type “!” BEFORE a CLI command, the switch ignores the command and returns you to the CLI prompt.

—If you type “!” after a CLI command, the switch displays an Invalid Command or Syntax Error error message.

Flood Rate Limiting

Problem:The options for setting flood rate limiting on 80-series, 10/100 Ethernet modules and on 80-series, 100 Base-FX Ethernet modules are incorrect. The correct rates are not available from the Web Agent or CLI.

18 June 14, 2001 610-0184-095