CONTENTS
3.1ELECTRICAL CONNECTIONS
Checking the power supply setting
ALS 256: A power supply setting is not re- quired.
The ALS 20X Label Dispenser is suitable for operation with a power supply of 230 V (AC) or 110 V (AC).
If you are unsure of what mains voltage your local electricity supplier provides, refer to a qualified service technician.
ALS 20x 256
GB
Check to see that the voltage that has been set conforms to the local mains voltage.
Switch setting | Permissible mains voltage |
|
|
115 |
230
[28]Permissible mains voltages for both positions on the voltage selector switch.
Changing the voltage setting:
Make sure that the power cable is disconnected.
Slide the switch [27A] to the respective opposite position.
–Insert a small screwdriver into the groove [27B] and move the red insert horizontally to the opposite stop position (to the left in Figure [27]).
Connecting the power cable.
Make sure that the power switch [29A] is set to ‘O’ (off).
Using the supplied power cable, plug the unit into a socket connected to the mains supply.
For more information on fuses, see section “Replacing fuses” on page 47.
A | B |
[27]Voltage selector switch on the ALS 20X (set to 230 V in the figure)
A
B
[29] Power cable (B) plugged in.
30
