Avery 206, 204, 256 manual ALS 20x

CONTENTS

6.1ERROR MESSAGES

ALS 20x 256

GB

Status Status text Cause Action to take

5026 MotorProtect CPU – (ALS 256) Dust filter liner exhausted. This leads to overheating the ma- chine.

–(ALS 20X) Voltage selection switch set faulty.

–There are some more possible caus- es, which require a qualified service technician to cure.

Renew the dust filter liner.

Check setting of the voltage selectio- in switch.

If none of the above listed actions is successful, search for technical as- sistance.

5140 Rewinder control Rewinder control		Press the	key.
	During problem-free operation,	– This reinitialises the dancer arm con-
		trol; the dancer arm moves back into
	the rewind unit dancer arm only
		the control position.
	moves a minimal distance
	around the "control position".
	This is the position the dancer
	arm takes up after initialisation
	of the machine.

–Any force applied that moves the dancer arm from its control position.

Example: The feed motor is blocked; the backing paper is not conveyed quickly enough; as a result the dancer arm is pulled upwards.

Example: The backing paper is torn; the dancer arm springs downwards.

5143 Rewinder Stop	– This message appears when the	Press the	key to confirm the er-
	dancer arm was held against its up-	ror message.
	per stop for more than two seconds.

Effect:

Power to the rewinder motor is switched off, so that the rewinder can be turned easily by hand.

This effect is helpful when in- stalling a new label roll, because the rewinder can be turned easily.

5145 Material feed	The maximum permitted diameter	Remove the rewound backing paper
	(205 mm) for the rewinder roll has been		This error can only occur if the
	reached.
			end of a new label roll was glued
			on to backing paper that had al-
			ready been wound onto the re-
			winder.
		Press the		key to confirm the er-
		ror message.

[53] List of error messages

51