CONTENTS

3.2INSERTING LABEL MATERIAL

3.2.2Inserting a label roll

WARNING!

Risk of injury due to moving and rapidly rotating parts!

Before inserting the label roll, ensure that the device is turned off at the main switch.

Do not under any circumstances turn the device on before the label strip is threaded in completely.

Removing spent backing paper

Assuming backing paper has gathered on the rewinder

[32A] :

Press the release button [32B].

The tensioning mechanism of the rewinder is slackened.

Remove the rewound backing paper.

Removing glue residue

If necessary, clean the following components:

Dispensing plate

Deflection rollers

Drive rollers

Pressure roller

Follow the directions provided in section “Maintenance and cleaning” on page 47.

AB

[32]A Rewound backing paper B Release button

C Backing paper path

ALS 20x 256

GB

Inserting a new label roll

Push the material roll [33A] onto the unwinder as far as it will go.

Rotate the rotary knob [33B] in a clockwise direction until the label roll sits tightly.

Run the label strip around the dancer arm as shown in the figure [33C].

B

A

C

[33] Inserting the material roll – Part 1.

33

Page 37
Image 37
Avery 206, 204, 256 Inserting Label Material, Inserting a label roll, Removing spent backing paper, Removing glue residue