
CONTENTS | ALS |
20x | |
4.2 CONFIGURATION AND MONITORING | 256 |
|
| GB | |
Label position on the product |
| |
Prerequisites: |
| |
– The label length must be specified. |
| |
– The label stop position must be set. |
| |
Configuration in dispensing mode: |
| |
Use the two right buttons to set the start offset (see |
| |
“Online settings” on page 22). |
| |
Or use the function menu settings: |
| |
Call the LABEL SETUP > Start Offset function and set the | A | |
start offset. |
| |
– The label should be flush with the front edge of the |
| |
product: | [47] Distance between the product sensor (left) and the | |
Enter the distance between the product sensor and | ||
dispensing edge (right). | ||
the dispensing edge [47A]. | ||
|
–The label should be stuck at a distance from the front edge of the product:
Increase the start offset by the distance [48A] to the product’s front edge.
A
[48] Distance (A) between the label and the product’s front
43