Axis Communications Destinations on, Axis 700 display shows Send to xxxxxx when it is

56 gywi Xg D77 AXIS 700 User’s Manual

y

va	ο Before scanning to an e-mail address or a file, the Administrator
			must have set up the destinations as described in “Specifying
			Destinations” on page 40.
	Perform these instructions from the AXIS 700 control panel:
	1.		The AXIS 700 display shows “Send to: xxxxxx” when it is
		ready for use. For example:
			6HQG￿WR￿
			$FFRXQWLQJ￿'HSW
	2.
		Use			to scroll through the destination list, until you find
		the desired destination. Press and hold the key to autorepeat the
		scrolling. If needed, you can add e-mail destinations temporarily. See
		“Adding Temporary Destinations ”on page 59.
	3.	If you want to send the image to more than one destination, press
		Enter		to select each destination:

6HQG￿WR￿￿ ￿ ￿ ￿ ￿✓ $FFRXQWLQJ￿'HSW￿

4.Repeat steps 2 and 3, until all desired destinations are selected.

va	ο Be careful not to transmit images to an unwanted destination.
	The scanned image will always be sent to the destination currently
	shown in the display, whether explicitly selected or not.
	5. Optionally, press Menu	to change the default settings for
	scanning parameters. You can select temporary settings for profile,
	paper size and double-sided. Use		to select the desired
	value.

va	ο Press Cancel	to reset all temporary settings to the default
	values.

6.Insert a single page on the flatbed or a stack of paper into the sheet feeder of the attached scanning device.