Axis Communications 700 user manual Cdb

AXIS 700 User’s Manual Appendix A: Troubleshooting 73

i s

This table lists the error and warning messages that might appear on the AXIS 700 message display:

u	l
Scanner lamp failure		The lamp in the scanner is broken. See the scanner
		manual for instructions.
Scanner fuse blown		A fuse in the scanner is broken. See the scanner manual
		for instructions.
Scanner compression		The image compression unit in the scanner did not work
unit failure		properly. Contact your scanner supplier.
Scanner hardware		The scanner reports a hardware failure. Contact your
failure		scanner supplier.
Scanner firmware failure		The scanner reports a software failure. Contact your
		scanner supplier.
SCSI parameter length		The length of the SCSI command is illegal. Contact your
illegal		scanner supplier.
Invalid SCSI command		The scanner does not support the given SCSI command.
		Contact your scanner supplier.
Invalid field in SCSI		The SCSI command includes an invalid field. Contact
CDB		your scanner supplier.
SCSI command		The scanner cannot receive the SCSI commands in the
sequence illegal		order they were sent. Contact your scanner supplier.
Invalid field in SCSI		The SCSI parameter block includes one or several invalid
parameter list		fields. Contact your scanner supplier.
Scanner not ready,		An error has occurred in the communication between the
		scanner and the AXIS 700. For example the copier might
please check scanner
		have been taken out of scan mode and does not respond
and restart the scan
		to any commands. That is why the scanner should be
server.
		checked and the AXIS 700 restarted.
A timeout has occurred		The AXIS 700 has not had any communication with the
on the scanner, the job		scanner and the scanner has timed out. Scan the
has been canceled		documents again.
		The scanned image contains too much data. Please try
Out of memory		another scanning profile. If required, you can expand the
		RAM memory as described on the AXIS 700 Support
		Web.
		The internal store in the copier has been filled up. This
		can happen if you scan a document with many pages in
Out of scanner image		the document feeder. When you press send, there is not
memory		enough internal memory to keep the pages. Please divide
		the pages and use the scan button instead. The whole
		document has to be re-scanned.