MN1921 Operation | Baldor iMN1921 guide

3.In the Select Controller dialog, go to the drop down box near the top and select the PC serial port to which the NextMove ST is connected. If you are unsure which PC serial port is connected to the drive, select Scan all serial ports.

Click Scan to search for the NextMove ST.

When the search is complete, click NextMove ST in the list to select it, and click the Select button.

Note: If the NextMove ST is not listed, check the serial lead between the NextMove ST and the PC and that the NextMove ST is powered correctly. Click Scan to re-scan the ports.

4.A dialog box may be displayed to tell you that WorkBench v5 has detected new firmware. Click OK to continue. WorkBench v5 reads back data from the NextMove ST. When this is complete, Fine-tuning mode is displayed. This completes the software installation.

MN1921

Operation 5-5

Image 39

Baldor iMN1921 installation manual MN1921 Operation

Contents

NextMove ST Motion Controller Page Contents Operation General Information Precautions Safety Notice MN1921 Introduction NextMove ST features Receiving and inspection Units and abbreviations Phase Introduction MN1921 You should read all the sections in Basic Installation IntroductionLocation requirements Mounting the NextMove ST Package dimensions Other requirements for installation Basic Installation MN1921 Input / Output Connector locations Operation using combined drive and logic supply Power connections Connecting separate drive and logic supplies Operation using separate drive and logic supplies Connecting a 4-wire motor Stepper outputsStepper axes 0-2 drive outputs Connecting a 6-wire motor Connecting a 8-wire motor, parallel windings Connecting a 8-wire motor Stepper output pin header J3, and output circuit shown Stepper axes 0-3 logic outputs Analog inputs Analog I/O Analog output Analog output Digital inputs Digital I/O Auxiliary Encoder inputs Auxstep IN, Auxdir IN, Auxz Using a digital input as a Limit or Home inputUsing a digital input as a Stop input Using a digital input as an Error input Digital output DOUT0 shown Digital outputs Jumper settings Error outputDriveenableoutput keyword Globalerroroutput keyword Pin Name Description Other I/ORS232 serial communication Location RS232 serial port connections 2 50-pin edge connector Typical can network connections Can communication CANopen and Baldor can JP1 This will connect an internal terminating resistor Host PC Connection summary minimum system wiring Input / Output MN1921 Preliminary checks Connecting the NextMove ST to the PCInstalling WorkBench Starting the NextMove ST Power on checks Help file WorkBench Starting WorkBench MN1921 Operation Selecting a scale Configuring an axis Click Apply Testing the output Stepper axis testing Digital input configuration Digital input/output configuration Digital output configuration Saving setup information Loading saved information SupportMe feature Problem diagnosis Status display NextMove ST indicators Surface mount LEDs D3, D4 and D16 Symptom Check CommunicationMotor control Output power Value Input power Output current max Update interval Immediate Common mode voltage rangeInput impedance 120 Input ADC resolution Bits Equivalent resolution ±10V input Unit Value Output type Stepper axis 0-2 drive outputsUnit Value Maximum output frequency KHz 200 Output voltage Output current maximum, per axis Channels Protocols CANopen Unit Value SignalCan interface Environmental Index Index MN1921 Comment Comments Comments MN1921 Page LT0184A00