General tips
Setting the resolution of your CORONIS display
Note: In order to set the resolution of your CORONIS you must be logged in using an account with administrator privileges.
1.Open the “Windows Display Control Panel” by one of the two methods below:
a)Start > Settings > Control Panel > Display
or
b)Open the “Display Properties Control Panel” by right clicking in an empty area on the desktop, then select
“Properties”.
2.Click on the “Settings” tab.
3.Select the rectangle that represents the Barco Coronis display whose settings you wish to change.
Note: If you are using the VGA capabilities of your BARCOMED
CORONIS display controller, the resolution for the first display may be set to a VGA resolution of “640 x 480” pixels with 16 colors and a default refresh rate. If your BarcoMed Coronis controller is not running VGA, the display may not be enabled yet. To enable the display, check the “Extend my Windows desktop onto this monitor” checkbox, but do NOT click the “Apply” button at this time.
If you installed your BARCO CORONIS Display System drivers in SingleView mode (default for Windows 2000) there will be one rectangle for the virtual display representing the two heads controlled by each BarcoMed Coronis display controller.
If you installed your BARCO CORONIS Display System drivers in DualView mode (default for Windows XP) there will be a rectangle representing each head controlled by each BarcoMed Coronis display controller. This will be true even if you have only one display connected to your BarcoMed Coronis controller. Both displays of a display controller cannot be enabled at the same time unless their display properties match. If necessary detach the second display of the BarcoMed Coronis display controller you are
102
