Barco MGP 15 user manual Introduction

Introduction

Proceed as follows:

1.Connect one video output of the first display controller to the BNC input of the first projector by means of the DVI-to-5 BNC cable (15 m / 50 ft) (Video 1 in the illustration above).

2.Connect the other PC video output of the first display controller to the DVI video input of the first display by means of the DVI cable (Video 2 in the illustration above).

3.Connect one video output of the second display controller to the BNC input of the second projector by means of the DVI- to-5 BNC cable (15 m / 50 ft) (Video 3 in the illustration above).

4.Connect the other PC video output of the second display controller to the DVI video input of the second display by means of the DVI cable (Video 4 in the illustration above).

5.Connect a free PC COM port to the RS-232 connector of the first projector by means of the D-Sub9-to-D-Sub9 cable (15 m / 50 ft).

6.Connect a free PC COM port to the RS-232 connector of the second projector by means of the D-Sub9-to-D-Sub9 cable (15 m / 50 ft).

7.Connect the first I-Guard optical sensor to a free PC USB downstream connector.

8.Connect the second I-Guard optical sensor to a free PC USB downstream connector. If the cable is not long enough, you have to use a USB booster/extender.

Installation of the sensor is described more in detail in the section “MediCal and Dicom Theater software installation and usage”.

Important:

Do not connect the two display inputs nor the two projector inputs to the same display controller. In other words, to each

20